Introduction to the characteristics of flash dryer

Flash dryer features:

1, flash dryer to choose a special feeder, linking the feeding of continuous and unchanged, will not occur bridging, arching, clustering phenomenon, especially for viscous materials.

2, because the drying time is short, the material to take the relative speed of the hot air and the hottest air does not take the material is not dry indirectly in contact with the use of heat-sensitive materials.

3, the bottom of the drying chamber of the inner cone layout, the air flow on the wall of the scouring and stirrer of the peculiar layout, decided to flash drying equipment can dispose of certain viscous materials.

4, because the drying process of the material meets the rupture, scouring, touching, profile area deletion, strengthen the drying, so the drying intensity of flash drying equipment is higher.

5, through the drying tower is set up to put inside (cyclone piece, with analysis ring or classifier), and to take the inlet and outlet air temperature of the same - co-ordination, flash drying equipment on the end of the material water and fineness of the finished product to be ineffective control.

6, the bottom of the drying room is equipped with a water spacer cooling device, to avoid the material is at the bottom of the high-temperature area of the occurrence of heat variable phenomenon.

7, the drying chamber circumferential gas speed is high, the material stays for a short period of time, effectively preventing the material from sticking to the wall and heat-sensitive materials variable.

8, flash dryer is operating under micro-negative pressure, eliminating the operation of pollution, and according to the different materials using different dust removal methods and dust removal materials (pulse punching bag dust collector, water bath dust collector, venturi wet dust collector, etc.). As a result, the work is clean and the environmental protection is up to the standard.